Component Inspection
VARIABLE OIL PUMP SOLENOID INSPECTION PROCEDURE
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
Variable oil pump solenoid valve (component side) | 1 (power) | Variable oil pump solenoid valve (component side) | 2 (control) | Approx. 0.2Ω (20°C (68°F)) |
Good
- Fault is intermittent caused by poor contact in the sensor's and/or ECM's connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and Go to "VERIFICATION OF REPAIR " procedure.
No Good
- Carefully re-do this troubleshooting guide steps.
- If no problems were found with the circuits or connectors, replace the variable oil pump solenoid valve and Go to "VERIFICATION OF REPAIR " procedure.