Component Inspection: Notes
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
HSG (component side) | 1 (+) | HSG (component side) | 6 (-) | 13.8Ω to 17.8Ω/20° C to 30°C (68°F to 86°F) |
| HSG (component side) | 2 (S1) | HSG (component side) | 7 (S3) | 26.2Ω to 30.2Ω/20° C to 30°C (68°F to 86°F) | |
| HSG (component side) | 3 (S2) | HSG (component side) | 8 (S4) | 26.2Ω to 30.2Ω/20° C to 30°C (68°F to 86°F) | |
| HSG (component side) | 1 (+) | HSG (component side) | 10 (shield ground) | More than 10MΩ | |
| HSG (component side) | 1 (+) | HSG (component side) | 9 (ground) | More than 10MΩ | |
| HSG (component side) | 6 (-) | HSG (component side) | 10 (shield ground) | More than 10MΩ | |
| HSG (component side) | 6 (-) | HSG (component side) | 9 (ground) | More than 10MΩ | |
Good
- Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
- Repair or replace as necessary and then go to "VERIFICATION OF REPAIR " procedure.
No Good
- Carefully re-do this troubleshooting guide steps.
- If problem still occurs, repair or replace HSG position sensor and then go to "VERIFICATION OF REPAIR " procedure.
CAUTION:
Perform
"Engine Clutch/Motor Resolver Adaptation" with KDS in case HPCU or motor is replaced or repaired, and then operate Electric Water Pump (EWP) to recirculate and refill coolant.