Repair Procedures: Installation: Notes
- Remove the ignition key from the vehicle.
- Disconnect the battery negative cable and wait for at least 30 seconds before beginning to work.
- Install the SRSCM with the SRSCM mounting bolts.
Tightening torque:
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)
NOTE: Use new mounting bolts when replacing the SRSCM after a collision. - Connect the SRSCM harness connector.
- Install floor console.
(Refer to Body - "FLOOR CONSOLE ")
- Reconnect the battery negative cable.
- After installing the SRSCM, confirm proper system operation:
- Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
- SRSCM senses vehicle rollovers. SAB, CAB, BPT may deploy if a technician moves the SRSCM from the vehicle in IGN ON state. For this reason, turn the IGN OFF before safely removing the SRSCM from the vehicle.
- When the SRSCM is replaced, always perform variant coding. Also, perform the lateral G sensor 0-point setup.
(Refer to Brake System - "YAW-RATE AND LATERAL G SENSOR ")