DTC Information: DTC Detecting Condition

Item	Detecting Condition	Possible Cause
DTC Strategy	Voltage Range check	Poor connection Open or short to ground in power harness Open or Short to ground in signal harness TPS ECM
Enable Conditions	Ignition switch is "ON" condition Engine operating state at idle (gas pedal value is less than 0.01%) TPS set point is lower than 61.078° TPS 1 and TPS 2 ratio failure is detected or TPS 1 failure is detected
Threshold Value	TPS_2 voltage is lower than 0.1V TPS_2 voltage is lower than 2.0V at engine idle Short circuit to ground or open circuit
Diagnosis Time	0.05s
MIL On Condition	1 driving cycle