Conditions And Calibration Procedures
- Replacing only Direct Electro Hydraulic Actuator Coupling
Clutch Learning Reset
(S/W Management → 4WD Control → Clutch Learning Reset)
Information
Refer to the KDS screen for operating conditions and details
- Replacing only AWD ECU
Adaptive Value BackUp & Input (ECU replacement)
(S/W Management → 4WD Control → Adaptive Value BackUp & Input (ECU replacement))
Information
Refer to the KDS screen for operating conditions and details
- Replacing transfer case assembly and AWD ECU
Adaptive Value BackUp & Input (ECU & Transfer Assy replacement at once)
(S/W Management → 4WD Control → Adaptive Value BackUp & Input (ECU & Transfer Assy replacement at once))
Information
Refer to the KDS screen for operating conditions and details
- If a DTC about fault torque or bleeding pressure occurs, bleed the air inside the oil.
Air Bleeding Mode
(S/W Management → 4WD Control → Air Bleeding Mode)
Information
Refer to the KDS screen for operating conditions and details
- If the used 4WD ECU is installed.
Initialize 4WD ECU
(S/W Management → 4WD Control → Initialize 4WD ECU)
Information
Refer to the KDS screen for operating conditions and details