Removal & Installation: Installation
WARNING: This page is about a different variant/trim than selected.
- Install in reverse order of removal.NOTE:
- Install the Electronic Throttle Control (ETC) module to the specified torque.
- If the ETC module is dropped, it may cause internal damage. (Do not reuse)
- Replace with a new gasket (A) and check to verify that the gasket seats properly before Installation.
- Reset the Engine Control Module (ECM) adaptive values after replacing the ETC.
(S/W Management → Engine Control → Resetting Adaptive Values)
Information
Refer to the KDS screen for operating conditions and details
- Perform the Electronic Throttle Control (ETC) module learning procedure.
(Refer to ELECTRONIC THROTTLE CONTROL (ETC) MODULE - ADJUSTMENT )