Power Steering System
- Ensure fluid in reservoir reaches dipstick maximum.
- Run engine to normal operating temperature.
- Recheck and correct reservoir fluid level. See FLUID LEVEL CHECK
under LUBRICATION.NOTE: During steps 4) through 6) , maintain a maximum fluid level in the reservoir. Do not increase engine speed or move steering wheel.
- With engine at idle speed, loosen bleed screw. See Fig 1 . When fluid seeps past bleed screw, retighten screw.
- Check fluid level.
- Clean away fluid around bleed screw.
- Check hose connections, pump and steering box for fluid leaks by holding steering on full lock in both directions.
- Carry out road test.
CAUTION:
Do not maintain this pressure for more than 30 seconds in any one minute to avoid overheating fluid and possibly damaging seals.