BLUETOOTH Module (Tel)

CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault, and may also cause additional faults in the vehicle being tested and/or the donor vehicle.

NOTE: If the control module or a component is suspect and the vehicle remains under manufacturer warranty, refer to the Warranty Policy and Procedures manual (section B1.2), or determine if any prior approval program is in operation, prior to the installation of a new module/component.

NOTE: Generic scan tools may not read the codes listed, or may read only 5-digit codes. Match the 5 digits from the scan tool to the first 5 digits of the 7-digit code listed to identify the fault (the last 2 digits give extra information read by the manufacturer-approved diagnostic system).

NOTE: Check and rectify basic faults before beginning diagnostic routines involving pinpoint tests.

NOTE: Inspect connectors for signs of water ingress, and pins for damage and/or corrosion.

NOTE: If DTCs are recorded and, after performing the pinpoint tests, a fault is not present, an intermittent concern may be the cause. Always check for loose connections and corroded terminals.

The table below lists all Diagnostic Trouble Codes (DTCs) that could be logged in the Bluetooth Module, for additional Diagnosis and Testing information refer to the relevant Diagnosis and Testing. For additional information, refer to: Cellular Phone (415-00 Information and Entertainment System - General Information, Diagnosis and Testing).

DTC	Description	Possible Causes	Action
B1D79-84	Microphone Input - Signal below allowable range	The 'Receive Audio over MOST Test' failed and means that the audio received at the microphone detection point is too low Microphone fault Harness/connector fault Integrated head unit (IHU) fault	Check the operation of the microphone. Refer to the electrical circuit diagrams and check the microphone (MIC) circuits. Renew/repair as necessary. Refer to the warranty policy and procedures manual if a module is suspect.
U1A00-88	Private Communication Network - Bus off	Internal communications failure	Clear the DTC and retest. If the problem persists, renew the Bluetooth Module. Refer to the warranty policy and procedures manual if a module is suspect.
U2001-9A	Reduced System Function - Component or system operating conditions	Bluetooth error - system over-temperature	Allow the system to cool, clear the DTC and check /monitor for re-occurrence. If DTC re-occurs suspect the module. Check and install a new module as required. Refer to the Warranty Policy and Procedures manual if a module is suspect.
U201A-54	Control Module Main Calibration Data - Missing calibration	Local configuration file is missing (not loaded) in the control module	Configure the module using the manufacturers approved diagnostic system (file download may take several minutes).
U3000-44	Control module - Data memory failure	Bluetooth Module RAM fault (data memory failure leading to possible corrupt local configuration file)	Configure the module using the manufacturers approved diagnostic system and download the local configuration file. Clear the DTC and retest. If the problem persists, renew the Bluetooth Module. Refer to the warranty policy and procedures manual if a module is suspect.
U3000-45	Control module - Program memory failure	Bluetooth Module ROM fault (data memory failure leading to possible corrupt local configuration file)	Configure the module using the manufacturers approved diagnostic system and download the local configuration file. Clear the DTC and retest. If the problem persists, renew the Bluetooth Module. Refer to the warranty policy and procedures manual if a module is suspect
U3000-54	Control module - Missing calibration	MOST not configured correctly - incorrect voice language installed	Check and amend the Car Configuration File in the Information and Entertainment Control Module using the manufacturer approved diagnostic system.
U3000-56	Control module - Invalid/incomplete configuration	One or more of the received car configuration file (CCF) data parameters is deemed to be invalid	Check and amend the Car Configuration File using the manufacturer approved diagnostic system.
U3003-16	Battery Voltage - Circuit voltage below threshold	Battery voltage below threshold	Check vehicle battery and charging system. Refer to the relevant section in the workshop information. Refer to the electrical circuit diagrams and check the power supply circuits to the module.
U3003-17	Battery Voltage - Circuit voltage above threshold	Battery voltage above threshold	Check vehicle battery and charging system. Refer to the relevant section in the workshop information. Refer to the electrical circuit diagrams and check the power supply circuits to the module.