LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2009 >> Range Rover HSE >> Repair and Diagnosis >> External Pages >> Different car >> Section 128 (Anti-Lock Control - Traction Control) >> Anti-Lock Control - Traction Control >> Removal And Installation >> Front Wheel Speed Sensor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Front Wheel Speed Sensor: Removal

WARNING: This page is about a different car, the 2006 Land Rover Range Rover Sport. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

    WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
  1. Raise and support the vehicle.
  2. Remove the front wheel and tire.
  3. Remove the fender splash shield. Refer to Fender Splash Shield article.
  4. Release the wheel speed sensor lead from the brake hose retaining bracket.
    GJ0015007

    5. Vehicles with standard brakes 

    CAUTION: Do not allow the brake caliper to hang on the brake hose.
  5. Release the brake caliper anchor plate from the wheel knuckle and tie the caliper aside.
    • Remove the 2 retaining bolts.
    GJ0015008

    6. Vehicles with high performance brakes 

    CAUTION: Do not allow the brake caliper to hang on the brake hose.
  6. Release the brake caliper from the wheel knuckle.
    • Remove the 2 retaining bolts.
    • Tie the brake caliper aside.
    GJ0015009

    7. All vehicles 

    NOTE: The brake disc is shown removed for clarity.
  7. Release the wheel speed sensor from the wheel knuckle.
    • Remove the bolt.
    GJ0013411
  8. Remove the wheel speed sensor.
    • Disconnect the electrical connector.
    • Release the wiring harness from the clips.
    GJ0015010
scientia non olet · About LEMON Manuals