Symptom Chart
WARNING: This page is about a different car, the 2006 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
| Symptom | Possible Cause | Action |
|---|---|---|
| Lost satellite reception |
|
NOTE:
Time taken to lock on to satellites can be several minutes after ignition status is switched to 'ON' It is possible for the GPS antenna to lose satellite reception in hilly or tree-lined areas, built-up areas, in multi-storey car parks, tunnels or during heavy rain or thunderstorms. Check for DTCs indicating an antenna or navigation module fault. |
| Touch screen display (TSD) displays a high temperature message and shuts down |
|
Check MOST FOT temperature in TSD diagnostics, vehicle signals. Once the temperature is reduced the system will resume normal operation. If the system does not resume normal operation, check for DTCs indicating an information and entertainment system fault. |
| Touch screen display (TSD) displays a low temperature message and shuts down |
|
Check MOST FOT temperature in TSD diagnostics, vehicle signals. Once the temperature is increased the system will resume normal operation. If the system does not resume normal operation, check for DTCs indicating an information and entertainment system fault. |
| Blank screen |
|
Refer to Pinpoint Test A . |
| No display on navigation screen (screen does not change) |
|
Refer to Pinpoint Test B . |
| Hard switches do not respond |
|
Refer to Pinpoint Test C . |
| Radio screen will not display (Range Rover Only) |
|
Refer to Pinpoint Test D . |
| CD screen will not display (Range Rover Only) |
|
Refer to Pinpoint Test E . |
| TV/DVD screen will not display |
|
Refer to Pinpoint Test F . |
| AUX. screen will not display (Range Rover Only) |
|
Refer to Pinpoint Test G . |
| Display screen will not switch to low light |
|
Refer to Pinpoint Test H . |
| Noise interferes on each screen and the colors are abnormal |
|
Refer to Pinpoint Test I . |
| Disturbance on screen (synchronization abnormal) |
|
Refer to Pinpoint Test J . |
| Screen color is abnormal |
|
Refer to Pinpoint Test K . |
| Map disc will not insert/eject |
|
Refer to Pinpoint Test L . |
| Touch switches do not respond |
|
Refer to Pinpoint Test M . |
| Considerable deviation between displayed vehicle position and actual position |
|
Refer to Pinpoint Test N . |
| GPS mark does not appear |
|
Refer to Pinpoint Test O . |
| No sound |
|
Refer to Pinpoint Test P . |
| No voice recognition |
|
Refer to Pinpoint Test Q . |
| Vehicle current position mark turns on its own |
|
Refer to Pinpoint Test R . |
| Vehicle position does not update |
|
Refer to Pinpoint Test S . |
| Route calculations cannot be performed |
|
Refer to Pinpoint Test T . |
| Map display is incomplete |
|
Refer to Pinpoint Test U . |
| Vehicle position mark moves in the opposite direction to the direction of travel |
|
Refer to Pinpoint Test V . |
| Cannot make or receive calls with the bluetooth telephone - cannot connect to the vehicle |
|
Refer to Pinpoint Test W . |
| 'NAVIGATION NOT INSTALLED' message displayed |
|
Refer to the electrical circuit diagrams and check navigation module power and grounds, and private CAN circuit |
| 'NO NAVIGATION AVAILABLE' message displayed |
|
Carry out GVIF checks, refer to the electrical circuit diagrams and check electrical harness for short, open circuit |