Anti-Lock Brake System (Abs) Module: Installation
WARNING: This page is about a different car, the 2013 Land Rover LR4, 2012 Land Rover LR4, 2011 Land Rover LR4, and 2010 Land Rover LR4. However, it is still accessible from the selected car via links, so may be relevant.
- Install the ABS module.
- Tighten the 2 ABS module retaining nuts to 8 Nm (6 lb.ft).
- Remove the blanking caps from the ports.
- Tighten the two M10 and three M12 brake tube unions to 15 Nm (11 lb.ft).
- Tighten the M14 brake tube union to 17 Nm (13 lb.ft).
- Connect the electrical connector.
- Remove the ABS module from the mounting bracket.
- Using T4, bleed the braking system. Refer to Brake System Pressure Bleeding article.
- Install the cover.
- If a new ABS module has been installed, interrogate the ABS system using T4.
NOTE:
Make sure the ABS module locating grommet is correctly seated in the bracket before installing the ABS module.
NOTE:
Make sure the ABS module locating pin is correctly located in the grommet, and the 2 front isolators are fully seated in the bracket slots.