LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR2 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Anti-Lock Control - Traction Control) >> Anti-Lock Control - Traction Control >> Removal And Installation >> Front Wheel Speed Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Front Wheel Speed Sensor: Installation

WARNING: This page is about a different car, the 2013 Land Rover LR4, 2012 Land Rover LR4, 2011 Land Rover LR4, and 2010 Land Rover LR4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Make sure the wheel speed sensor location in the wheel knuckle is free of dirt.
    2. NOTE: Make sure the electrical connector retaining clip is attached to the body wiring harness.
  2. Install the wheel speed sensor.
    • Connect the electrical connector.
    • Attach the wiring harness to the 5 clips.
    • Tighten the bolt to 9 Nm (7 lb.ft).
  3. Secure the brake caliper and anchor plate to the wheel knuckle.
    • Tighten the bolts to 275 Nm (203 lb.ft).
  4. Secure the brake hose retaining bracket to the wheel knuckle.
    • Tighten the bolt to 25 Nm (18 lb.ft).
  5. Install the fender splash shield. Refer to Fender Splash Shield article.
  6. Install the wheel and tire.
    • Tighten the wheel nuts to 140 Nm (103 lb.ft).
  7. Depress the brake pedal several times, check the fluid level in the brake fluid reservoir and top-up with brake fluid if necessary.
  8. If a new wheel speed sensor has been installed, interrogate the ABS system using T4.
scientia non olet · About LEMON Manuals