Rear Wheel Speed Sensor: Installation
WARNING: This page is about a different car, the 2013 Land Rover LR4, 2012 Land Rover LR4, 2011 Land Rover LR4, and 2010 Land Rover LR4. However, it is still accessible from the selected car via links, so may be relevant.
- Make sure the wheel speed sensor location in the wheel knuckle is free of dirt.
- Install the wheel speed sensor.
- Attach the wiring harness to the 4 clips.
- Secure the wheel speed sensor to the wheel knuckle.
- Tighten the bolt to 9 Nm (7 lb.ft).
- Attach the wiring harness to the clip.
- Connect the ABS sensor electrical connector.
- Attach the wiring harness.
- If a new wheel speed sensor has been installed, interrogate the ABS system using T4.
NOTE:
Make sure the electrical connector retaining clip is attached to the body wiring harness.