DTC C0062-28: Longitudinal Acceleration Sensor - Signal bias level out of range/zero adjustment failure: Action
WARNING: This page is about a different car, the 2016 Land Rover LR4, 2015 Land Rover LR4, and 2014 Land Rover LR4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
After clearing the DTCs, the warning indicator(s) may not extinguish until the vehicle speed has exceeded 10mph (15kph)
- Check the installation of the yaw rate lateral acceleration sensor
- Using the manufacturer approved diagnostic system, clear the DTCs and retest. If the fault persists, install a new yaw rate lateral acceleration sensor. Perform routine - Calibrate Acceleration Sensor(s) (0x300F)