DTC C0063-27: Yaw Rate Sensor - Signal rate of change above threshold: Action
WARNING: This page is about a different car, the 2016 Land Rover LR4, 2015 Land Rover LR4, and 2014 Land Rover LR4. However, it is still accessible from the selected car via links, so may be relevant.
- Refer to the appropriate system wiring diagrams and check the yaw rate lateral acceleration sensor power and ground circuits for open circuit, high resistance
- Using the manufacturer approved diagnostic system, perform a CAN network integrity test. Refer to the appropriate system wiring diagrams and check the private high speed CAN bus circuit for short circuit to ground, open circuit, high resistance
- Check the installation of the yaw rate lateral acceleration sensor
- Using the manufacturer approved diagnostic system, clear the DTCs and retest. If the fault persists, install a new yaw rate lateral acceleration sensor. Perform routine - Calibrate Acceleration Sensor(s) (0x300F)
- Using the manufacturer approved diagnostic system, clear the DTCs and retest. If the fault persists, install a new anti-lock brake system control module