DTC U3000-54: Control Module - Missing calibration: Action

WARNING: This page is about a different car, the 2016 Land Rover LR4, 2015 Land Rover LR4, and 2014 Land Rover LR4. However, it is still accessible from the selected car via links, so may be relevant.

Check the following criteria have all been achieved:
- Ignition status set to RUN/START
- Verify seat is always empty after power-up before re-zero is requested
- The occupant classification sensor control module has gone through the seat assembly plant calibration
- No collision event received from the restraints control module during the current ignition cycle
- No faults present in the current ignition cycle
- The trigger message for calibrate empty seat offset has been received from the diagnostic tool
- Occupant classification sensor control module has enough time to begin classification
- Temperature is between 6°C (42°F) and 36°C (97°F)