DTC C0063-64: Yaw Rate Sensor - Signal plausibility failure: Action

NOTE: This DTC can be set if the vehicle is being tested on chassis dyno rollers.

Ensure the sensor is correctly secured. Check that the steering angle sensor is correctly calibrated using the manufacturers recommended diagnostic system. If problem persists, renew the sensor. After rectification, either clear the DTCs and cycle the ignition or cycle the ignition and drive the vehicle above 80kph (not always in a straight line) to ensure the lamps extinguish. When cycling the ignition, allow sufficient time for the 'P' symbol illumination to extinguish on the gear shifter (if installed) before returning the ignition state to on