Removal And Installation: Installation

All vehicles

1. Install the ABS module.

   Torque Specification: 10 Nm 

2. Install the brake fluid tubes.

   Torque Specification: 15 Nm 

3. Install the battery tray support.

   Torque Specifications: 

   M6 10 Nm 

   M8 25 Nm 

   Left-hand drive vehicles

4. Connect the brake booster vacuum line.

   All vehicles

5. Install the ECM.
6. Secure the vacuum line and harness.

   Left-hand drive vehicles

7. Install the windshield wiper motor and linkage.

   Refer to: Windshield Wiper Motor .

   Right-hand drive vehicles

8. Install the plenum chamber panel.

   All vehicles

9. Install the battery tray.

   Refer to: Battery Tray .

10. Connect the battery ground cable.

    Refer to: BATTERY DISCONNECT/CONNECT .

11. Bleed the brake system.

    Refer to: Brake System Bleeding .

12. If a new component has been installed, configure using Land Rover approved diagnostic equipment.