DTC P0741-07: Torque Converter Clutch Circuit Performance/Stuck Off - Mechanical failures: Action
NOTE:
A new automatic transmission is supplied complete with a new transmission control module. After installing a new automatic transmission, perform routines - Configure New Module (Including Transmission Replacement), Transmission Control Module Adaption.
- Refer to the electrical circuit diagrams and check the torque converter pressure control valve solenoid circuit for short circuit to ground, short circuit to power, open circuit, high resistance. Repair the wiring harness or install a new solenoid as necessary
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and perform a road test using all gears. If the fault persists, refer to the relevant section of the workshop manual and check the automatic transmission fluid level and condition:
- Automatic transmission fluid normal: Install a new torque converter
- Automatic transmission fluid dirty or contaminated: Install a new automatic transmission