DTC P0894-07: Transmission Component Slipping - Mechanical failures: Action

NOTE: The All Wheel Drive System Pump Bleed routine must be performed after all rear drive unit hydraulic system repairs.

Refer to the relevant section of the service information and check the rear drive unit hydraulic fluid level
Check the rear drive unit hydraulic pipes for damage/blockages
Using the Jaguar Land Rover approved diagnostic equipment, reconfigure the all wheel drive control module with the latest level software
Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest. If the fault persists, install a new power transfer unit. For additional information, refer to: TRANSFER CASE - INGENIUM I4 2.0L PETROL, VEHICLES WITH: ACTIVE DRIVELINE .
Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest. If the fault persists, install a new all wheel drive control module.
For additional information, refer to: DIFFERENTIAL CONTROL MODULE (Removal and Installation).