DTC B1B44-96: Right Rear Outer Sensor - Component internal failure: Action

NOTE: This DTC will log if the local ground of the sensor is open circuit

Refer to appropriate system wiring diagrams and check the rear bumper harness for damage/corrosion. Check sensor circuit for short circuit to ground, short circuit to power, open circuit. Repair or install a new wiring harness as necessary
Check the connector for integrity and damage, then reconnect sensor to confirm connection
Using JLR approved diagnostic equipment, clear the DTCs and perform routine - On Demand Self Test (0x0202)
If the problem persists remove the suspect sensor from the bumper. Inspect the sensor connector for signs of water ingress/corrosion. Exchange the relevant sensor with a fault-free sensor. Clear the DTCs and perform routine - On Demand Self Test (0x0202). If a DTC is set for the new position of the suspect sensor, install a new sensor