DTC P0810-28: Clutch Position Control Error - Signal bias level out of range/zero adjustment failure: Action
- Using the Jaguar Land Rover approved diagnostic equipment, select the DTC-associated Guided Diagnostics to facilitate an Initial Position Search calibration
- If the fault persists, refer to the and check the security and integrity of the transfer case control module and high/low range position sensor connectors and rectify as required. Check the transfer case control module circuits for open circuit, high resistance. Repair circuit as required, clear DTC and retest
- Start the engine and, using the Jaguar Land Rover approved diagnostic equipment, clear DTC and retest. If the fault persists, install and configure a new high/low range position sensor. Refer to the High/Low Range Position Sensor Replacement Application instructions in the relevant Diagnosis and Testing Section For additional information, refer to: TRANSFER CASE
- If the fault persists, install a new transfer case control module and configure as a new module. Refer to the Transfer Case Control Module Replacement Application instructions in the relevant Diagnosis and Testing Section For additional information, refer to: TRANSFER CASE Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest