DTC U3006-85: Control Module Input Power "A" - Signal above allowable range: Action

NOTE: This DTC may be set when the vehicle is jump started.

Using the Jaguar Land Rover approved diagnostic equipment, perform the Transfer Case Healthcheck Application. The application will subsequently test the system and report a DTC if a fault persists
Refer to the appropriate system wiring diagram and check the transfer case control module power and ground circuits for short circuit to ground. Repair circuit as required, clear DTC and retest
Using the Jaguar Land Rover approved diagnostic equipment, check datalogger signals - Main ECU Voltage Supply (0xDD02) and Control Module Voltage (0xF442). Refer to the relevant section of the service information and test the battery and charging system