DTC U3000-05: Control Module - System programing failures: Action

NOTE: This DTC does not represent a fault and is triggered by routine diagnostic activity when the air suspension is requested to operate in tight tolerance mode

Connect a Jaguar Land Rover approved Midtronics battery power supply to the vehicle startup battery
Connect the Jaguar Land Rover approved diagnostic equipment to the vehicle and begin a new session. The diagnostic equipment will detect the correct Vehicle Identification Number (VIN) for the current vehicle and automatically take the vehicle out of transit mode if required
Following all the on-screen instructions, select 'ECU Diagnostics'; then, select 'Chassis Control Module [CHCM]'; then, select 'ECU Functions'; then, select 'Suspension geometry set-up' and, when prompted, select 'Normal Mode'. Continue to follow all the on-screen instructions until the application completes successfully. Finally, exit the current diagnostic session
Disconnect the diagnostic equipment and battery power supply from the vehicle. Clear the DTCs and retest to confirm the DTC is no longer present and any warning messages that may have been displayed on the instrument cluster are no longer showing