DTC B1A89-11: Satellite Antenna - Circuit short to ground: Action
- Confirm that the satellite digital audio radio service source is active on the screen, if the source is active go to step 10. If the source is inactive go to step 2
- Using the Jaguar Land Rover approved diagnostic equipment, perform routine - On Demand Self Test (0x0202) and read the Diagnostic Trouble Code(s). If the DTC is set go to step 3, if the DTC is no longer set go to step 10
- Refer to the electrical circuit diagrams and disconnect the satellite digital audio radio service antenna cable from the satellite digital audio radio service antenna
- Measure the voltage between pin 1 of the satellite digital audio radio service antenna cable and a local ground connection on the vehicle
- If the voltage is greater than 4.5 volts, go to step 8, if not go to step 6
- Disconnect the satellite digital audio radio service antenna cable from the front infotainment control module. Measure the resistance between pin 4 of the front infotainment control module connector harness side and a local ground connection on the vehicle
- If the resistance is less than 1Ω, replace the cable and go to step 2, if not go to step 9
- Reconnect the satellite digital audio radio service antenna cable to the satellite digital audio radio service antenna and the front infotainment control module. Perform routine - On Demand Self Test (0x0202). If the fault persists, install a new satellite digital audio radio service antenna
- Check the front infotainment control module software release notes to see if a repair is available and update the front infotainment control module and repeat step 2. If no software update is available go to step 10
- Check for other Diagnostic Trouble Code(s) relating to the customer concern and follow the DTC index