DTC P0810-07: Clutch Position Control Error - Mechanical failures: Action
- Using Jaguar Land Rover approved diagnostic equipment, select the DTC-associated Guided Diagnostics to perform a Learn Clutch Open and Close Point calibration. The Guided Diagnostics will subsequently test the system and report a DTC if a fault persists
- If the fault persists, install a new transfer case control module and configure as a new module. Refer to the Transfer Case Control Module Replacement Application instructions in the relevant Diagnosis and Testing service information. For additional information, Refer to: TRANSFER CASE Using Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest
- If the fault persists, contact Retailer Technical Support to seek approval for replacement of the transfer case prior to exchanging the unit.NOTE: The transfer case is supplied with a TCCM already installed and calibrated. Thus, there is no calibration work necessary. Refer to the Transfer Case Replacement Application instructions in the relevant Diagnosis and Testing service information. For additional information, Refer to: TRANSFER CASE