Transfer Case Control Module (G2413536): Installation
-
- Install the TCCM .
- Install and tighten the 2 bolts.
Torque : 18 Nm
- Connect the electrical connector.
- Connect the startup battery ground cable.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT
-
- Connect the Jaguar Land Rover (JLR) approved diagnostic equipment to the vehicle.
General Equipment: Jaguar Land Rover approved diagnostic equipment
- Start the diagnostic service function "transfer case-transfer case replacement".
- Clear any Diagnostic Trouble Code(s) (DTC) after calibration and check for correct operation.
- Connect the Jaguar Land Rover (JLR) approved diagnostic equipment to the vehicle.