DTC P18A5-11: Motion/Position Sensor A Signal Circuit - Circuit short to ground: Action
NOTE:
After installing a new rear differential control module, differential locking motor or electric differential, clear the DTCs and calibrate the system by performing routine - On Demand Self Test.
- Refer to the electrical circuit diagrams and check the differential locking motor position sensor signal 1 circuit for short circuit to ground. Repair the wiring harness as necessary
- Refer to the electrical circuit diagrams and check the differential locking motor position sensor signal 2 circuit for short circuit to ground. Repair the wiring harness as necessary
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and perform routine - On Demand Self Test. If the fault persists, install a new differential locking motor
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and perform routine - On Demand Self Test. If the fault persists, install a new rear differential control module