DTC P0716-61: Input/Turbine Shaft Speed Sensor "A" Circuit Range/Performance - Signal calculation failure: Action
- Prioritized steps to perform:
- Make sure the hybrid/EV battery pack is fully charged and rectify as required
- Using the Jaguar Land Rover approved diagnostic equipment, check for other transmission related DTCs and refer to the relevant DTC index
- Using the Jaguar Land Rover approved diagnostic equipment, reconfigure the transmission control module with the latest level software
- Check the security and integrity of the transmission ground point and check the resistance from the transmission ground to the vehicle ground. Rectify as required
- Check transmission VBATT and IGN circuits for voltage supply to transmission. Repair the wiring harness as necessary
- Inspect the transmission connector(s) for signs of water ingress, pin damage and/or corrosion. Rectify as required
- Clear DTC and retest. If the fault persists, raise a Technical Assist (TA) for further support