DTC B13D0-31: Roof Blind Position Sensor B - No signal: Action
NOTE:
To validate the repair run the engine for at least 30 seconds and operate the roof blind several times, then using the Jaguar Land Rover approved diagnostic equipment check that this Diagnostic Trouble Code(s) is not set within the body control module
- Using the approved Jaguar Land Rover approved diagnostic equipment, clear the Diagnostic Trouble Code(s)
- Try to perform 3 full open/close cycles of the roof blind
- Using the Jaguar Land Rover approved diagnostic equipment, perform the routine - Calibrate Roof Blind (204C). Clear the Diagnostic Trouble Code(s) and retest. If the fault persists, install a new front roof blind control module