DTC P3001-64: Driveline Disconnect Actuator Phase L1/L2/L3 - Signal plausibility failure: Action
- If available using the Jaguar Land Rover approved diagnostic equipment, select one of the following guided diagnostic concern areas below, or select the guided diagnostic using the available tab
- Powertrain - Transmission and Driveline - Loss Of Traction
- Warning - Messages - 2 wheel drive only - traction reduced
- Using the Jaguar Land Rover approved diagnostic equipment, re-configure the all wheel drive control module with the latest level software. Clear the DTCs and retest
- Refer to the appropriate system wiring diagrams and check the power transfer unit actuator circuit for open circuit, high resistance and check the actuator hall sensor circuits for short circuit to each other. If a circuit fault is present, repair the circuit as necessary. Clear the DTCs and retest
- If the fault persists, check and install a new driveline disconnect control module as necessary. Cycle the ignition and retest
- If the fault persists, check and install a new power transfer unit actuator as necessary