DTC P3042-01: Propshaft Speed Sensor - General electrical failure: Action

NOTE: If this DTC is logged with P3042-12, P3042-14 perform the repair action for these before performing the repair actions below

If available using the Jaguar Land Rover approved diagnostic equipment, select one of the following guided diagnostic concern areas below, or select the guided diagnostic using the available tab
- Powertrain - Transmission and Driveline - Loss Of Traction
- Warning - Messages - 2 wheel drive only - traction reduced
Refer to the appropriate system wiring diagrams and check the drive shaft speed sensor circuit for short circuit to power. Disconnect and re-connect connectors to check for poor connection. Repair circuit as necessary, clear the DTCs and retest
Using the Jaguar Land Rover approved diagnostic equipment, perform routine - On-Demand-Self-Test, repair any issues reported by the test
Start the engine. If the fault persists, check and install a new driveshaft speed sensor as necessary