DTC P0810-74: Clutch Position Control Error - Actuator Slipping: Action
- If available using the Jaguar Land Rover approved diagnostic equipment, select one of the following guided diagnostic concern areas below, or select the guided diagnostic using the available tab
- Powertrain - Transmission and Driveline - Loss Of Traction
- Warning - Messages - 2 wheel drive only - traction reduced
- Check for any other rear drive unit actuator DTC and repair these first. Clear the DTCs and cycle the ignition
- Using the Jaguar Land Rover approved diagnostic equipment, re-configure the all wheel drive control module with the latest level software. Clear the DTCs and retest
- Using the Jaguar Land Rover approved diagnostic equipment, run routine - Clutch Calibration
- If the fault persists, check and install a new rear drive unit as necessary, clear the DTCs and perform All-Wheel-Drive Healthcheck