DTC P3003-64: Driveline Disconnect Actuator Motion/Position Sensor Signal Circuit - Signal plausibility failure: Action
- If available using the Jaguar Land Rover approved diagnostic equipment, select one of the following guided diagnostic concern areas below, or select the guided diagnostic using the available tab
- Powertrain - Transmission and Driveline - Loss Of Traction
- Warning - Messages - 2 wheel drive only - traction reduced
- Using the Jaguar Land Rover approved diagnostic equipment, re-configure the all wheel drive control module with the latest level software. Clear the DTCs and retest
- Using the Jaguar Land Rover approved diagnostic equipment, perform routine - On-Demand-Self-Test, repair any issues reported by the test
- Refer to the appropriate system wiring diagrams and check the power transfer unit actuator hall sensor circuits for short circuit to ground, short circuit to power, open circuit, high resistance and ground noise transferred by the powertrain system. Repair circuit as necessary clear the DTC and retest
- If the fault persists, check and install a new driveline disconnect control module, clear the DTCs and start the engine
- If the fault persists, check and install a new power transfer unit as necessary