DTC P3000-1D: Driveline Disconnect Clutch Actuator - Circuit current out of range: Action
- Cycle the ignition and perform routine - On-Demand-Self-Test. If DTC is present within the On-Demand-Self-Test results, perform the following repair actions below. If the DTC is not present within the On-Demand-Self-Test results, clear the DTCs and perform All-Wheel-Drive Healthcheck
- Refer to the appropriate system wiring diagrams and check the power transfer unit actuator circuit for short circuit to ground, short circuit to power, open circuit, high resistance. If a circuit fault is present, repair the circuit as necessary and re-run On-Demand-Self-Test. If the DTC is not present within the On-Demand-Self-Test results, clear the DTCs and perform All-Wheel-Drive Healthcheck. If the DTC is present within the On-Demand-Self-Test results, perform the following repair actions below
- Check and install a new driveline disconnect control module as necessary and re-run On-Demand-Self-Test. If the DTC is not present within the On-Demand-Self-Test results, clear the DTCs and perform All-Wheel-Drive Healthcheck. If the DTC is present within the On-Demand-Self-Test results, perform the following repair actions below
- Check and install a new power transfer unit actuator motor as necessary. Clear the DTCs and re-run the All-Wheel-Drive Healthcheck