DTC P3001-13: Driveline Disconnect Actuator Phase L1/L2/L3 - Circuit open: Action
- Cycle the ignition and perform routine - On-Demand-Self-Test. If DTC is present within the On-Demand-Self-Test results, perform the following repair actions below. If the DTC is not present within the On-Demand-Self-Test results, clear the DTCs and perform All-Wheel-Drive Healthcheck
- Refer to the appropriate system wiring diagrams and check the Power transfer unit actuator motor circuits for open circuit high resistance. If a circuit fault is present, repair the circuit as necessary and re-run On-Demand-Self-Test. If the DTC is not present within the On-Demand-Self-Test results, clear the DTCs and perform All-Wheel-Drive Healthcheck. If the DTC is present within the On-Demand-Self-Test results, perform the following repair actions below
- Check and install a new driveline disconnect control module as necessary and re-run On-Demand-Self-Test. If the DTC is not present within the On-Demand-Self-Test results, clear the DTCs and perform All-Wheel-Drive Healthcheck. If the DTC is present within the On-Demand-Self-Test results, perform the following repair actions below
- Check and install a new power transfer unit as necessary. Clear the DTCs and re-run the All-Wheel-Drive Healthcheck