DTC P3006-1D: Clutch Actuator Phase L1/L2/L3 - Circuit current out of range: Action
- Cycle the ignition and perform routine - On-Demand-Self-Test. If DTC is present within the On-Demand-Self-Test results, perform the following repair actions below. If the DTC is not present within the On-Demand-Self-Test results, clear the DTCs and perform All-Wheel-Drive Healthcheck
- Refer to the appropriate system wiring diagrams and check the left rear drive unit actuator motor circuits for short circuit to ground, short circuit to power, open circuit, high resistance. If a circuit fault is present, repair the circuit as necessary and re-run On-Demand-Self-Test. If the DTC is not present within the On-Demand-Self-Test results, clear the DTCs and perform All-Wheel-Drive Healthcheck. If the DTC is present within the On-Demand-Self-Test results, perform the following repair actions below
- Check and install a new all wheel drive control module as necessary and re-run On-Demand-Self-Test. If the DTC is not present within the On-Demand-Self-Test results, clear the DTCs and perform All-Wheel-Drive Healthcheck. If the DTC is present within the On-Demand-Self-Test results, perform the following repair actions below
- If the fault persists, check and install a new left rear drive unit actuator motor as necessary. Clear the DTCs and re-run the All-Wheel-Drive Healthcheck