Inspection Procedure
WARNING: This page is about a different car, the 2005 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
- PERFORM ACTIVE TEST BY HAND-HELD TESTER
- Connect the hand-held tester to the DLC3.
- Check the cruise control switch using ACTIVE TEST.
COMBINATION METER:
COMBINATION METER DESCRIPTIONDescription Tester display Check condition CRUISE indicator light CRUISE INDIC ON-OFF - NG: REPAIR OR REPLACE COMBINATION METER ASSY
- OK: Go to Next Step
- READ VALUE OF HAND-HELD TESTER
- Connect the hand-held tester to the DLC3.
- Turn the ignition switch ON and push the hand-held tester main switch ON.
- Select the item below in the DATA LIST, and read the display on the hand-held tester.
CRUISE CONTROL (ECM):
CRUISE CONTROL (ECM)ITEM EXTEND PARAM CCS INDICATOR M Cruise Control Main Switch-Indicator (Main CPU) OFF/ON CCS INDICATOR S Cruise Control Main Switch-Indicator (Sub CPU) OFF/ON Result:
RESULTAll OK A All NG B Others B - B: REPLACE ECM (See ELECTRONIC CIRCUIT INSPECTION PROCEDURE )
- A: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN ON PROBLEM SYMPTOMS TABLE