System Check Mode (DTC Clear/Recheck)

HINT:

Graphics may differ from the actual vehicle depending on the device settings and options. Therefore, some detailed areas may not be shown exactly the same as on the actual vehicle.

1. Enter the diagnostic mode (see  DIAGNOSTIC START-UP/FINISH   ). 
2. Clear DTC 
   1. Press the "Code CLR" switch for 3 seconds.
      Fig 1: System Check Mode (DTC Clear/Recheck) - "Code CLR"

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. The check results are cleared.
3. Recheck 
   1. Press the "Recheck" switch.
      Fig 2: System Check Mode (DTC Clear/Recheck) - "Recheck"

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Confirm that all diagnostic codes are "OK" when the check results are displayed.

      If a code other than "OK" is displayed, troubleshoot again.

      Fig 3: System Check Mode (DTC Clear/Recheck) - "OK"

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Press the "LAN Mon" switch to change to "LAN Monitor" mode.
      Fig 4: System Check Mode (DTC Clear/Recheck) - "LAN Monitor"

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   4. Confirm that all diagnostic codes are "No Err".
      Fig 5: System Check Mode (DTC Clear/Recheck) - "No Err"

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   If a code other than "No Err" is displayed, troubleshoot again.