DTC U0073/94 Control Module Communication Bus OFF; DTC U0100/65 Lost Communication with ECM / PCM; DTC U0123/62 Lost Communication with Yaw Rate Sensor Module; DTC U0124/95 Lost Communication with Lateral Acceleration Sensor Module; DTC U0126/63 Lost Communication with Steering Angle Sensor Module: Description
The skid control ECU inputs the signals from the ECM, steering angle sensor, and yaw rate and acceleration sensor via CAN communication system.
DIAGNOSIS TROUBLE CODE CHART
| DTC No. |
DTC Detection Condition |
Trouble Area |
| U0073/94 |
When either of the following is detected:
- After the output of data from the skid control ECU is completed, the sending continues for 5 seconds or more.
- The condition that bus OFF state occurs once or more within 100 ms occurs 10 times in succession. (Sent signals cannot be received.)
- With the IG1 terminal voltage 10 V or more, a delay in receiving data from the yaw rate and acceleration sensor and steering angle sensor continues for 1 second or more.
- With the IG1 terminal voltage 10 V or more, the condition that a delay in receiving data from the yaw rate and acceleration sensor occurs more than once within 5 seconds occurs 10 times in succession within 60 seconds.
|
CAN communication system |
| U0100/65 |
When either of the following is detected:
- With the IG1 terminal voltage 10 V or more and the vehicle speed 9 mph (15 km/h) or more, data cannot be sent to the ECM for 2 seconds or more.
- With the IG1 terminal voltage 10 V or more and the vehicle speed 9 mph (15 km/h) or more, data from the ECM cannot be received for 2 seconds or more.
|
CAN communication system (Skid control ECU to ECM) |
| U0123/62 |
When either of the following is detected:
- With the IG1 terminal voltage 10 V or more, data from the yaw rate sensor cannot be received for 1 second or more.
- With the IG1 terminal voltage 10 V or more, the following occurs 10 times in succession within 60 seconds.
- The condition that data from the yaw rate sensor cannot be received occurs once or more within 5 seconds.
|
CAN communication system (Skid control ECU to yaw rate and acceleration sensor) |
| U0124/95 |
When either of the following is detected:
- With the IG1 terminal voltage 10 V or more, data from the acceleration sensor cannot be received for 1 second or more.
- With the IG1 terminal voltage 10 V or more, the following occurs 10 times in succession within 60 seconds.
- The condition that data from the acceleration sensor cannot be received occurs once or more within 5 seconds.
|
CAN communication system (Skid control ECU to yaw rate and acceleration sensor) |
| U0126/63 |
When either of the following is detected:
- With the IG1 terminal voltage 10 V or more, data from the steering angle sensor cannot be received for 1 second or more.
- With the IG1 terminal voltage 10 V or more, the following occurs 10 times in succession within 60 seconds.
- The condition that data from the steering angle sensor cannot be received occurs once or more within 5 seconds.
|
CAN communication system (Skid control ECU to steering angle sensor) |