Inspection Procedure

HINT:

Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not, whether the air-fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction (see FREEZE FRAME DATA ).

1. READ VALUE OF INTELLIGENT TESTER (FUEL PRESSURE) 
   1. Connect the intelligent tester to the DLC3.
   2. Start the engine and turn the tester ON.
   3. Enter the following menus: DIAGNOSIS / ENHANCED OBD II / DATA LIST / PRIMARY / FUEL PRESS.
   4. Read the values.

      Standard pressure: 

      4 to 13 MPa (40.8 to 132.6 kgf/cm ²  , 580 to 1,885 psi). 

   Result 

   FUEL PRESSURE SPECIFICATION
   
   

   Fuel Pressure (MPa)	Proceed to
   19.6 or more	A
   0.0	B
   OK (4 to 13 MPa [40.8 to 132.6 kgf/cm2 , 580 to 1,885 psi])*1	C
   (1) HINT: *:The value must change when the engine is running or stopped.

   B:  Go to step  3

   C: CHECK FOR INTERMITTENT PROBLEMS 

   A: Go to next step 

2. INSPECT FUEL PRESSURE SENSOR (VC VOLTAGE) 
   1. Disconnect the E72 fuel pressure sensor connector.
   2. Turn the engine switch on (IG).
   3. Measure the voltage according to the value(s) in the table below.

      Standard voltage 

      VOLTAGE SPECIFICATION
      
      

      Tester Connection	Specified Condition
      E72-3 (VC) - E72-1 (E2)	4.5 to 5.5 V

   Fig 1: Identifying Fuel Pressure Sensor Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NG:  GO TO STEP  4

   OK: Go to next step 

3. INSPECT FUEL PRESSURE SENSOR 
   1. Inspect the fuel pressure sensor (see INSPECTION ).

   NG: REPLACE FUEL PRESSURE SENSOR 

   OK: Go to next step 

4. CHECK HARNESS AND CONNECTOR (ECM - FUEL PRESSURE SENSOR) 
   1. Disconnect the E45 ECM connector.
   2. Disconnect the E72 fuel pressure sensor connector.
   3. Measure the resistance according to the value(s) in the table below.

      Standard resistance (Check for open) 

      RESISTANCE SPECIFICATION
      
      

      Tester Connection	Specified Condition
      E45-31 (VCPR) - E72-3 (VC)	Below 1 Ω
      E45-29 (PR) - E72-2 (PR)	Below 1 Ω
      E45-30 (EPR) - E72-1 (E2)	Below 1 Ω

      Standard resistance (Check for short) 

      RESISTANCE SPECIFICATION
      
      

      Tester Connection	Specified Condition
      E45-31 (VCPR) or E72-3 (VC) - Body ground	10 kΩ or higher
      E45-29 (PR) or E72-2 (PR) - Body ground	10 kΩ or higher

   Fig 2: Disconnecting E45 ECM Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

   OK: REPLACE ECM