HEIGHT CONTROL SENSOR (for Front LH): Removal

HINT:

• Use the same procedures for the RH side and LH side.
• The procedures listed below are for the LH side.

1. REMOVE COWL TOP VENTILATOR LOUVER RH  (See REMOVAL )
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
   CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
   NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
3. REMOVE FRONT WHEEL 
4. REMOVE HEIGHT CONTROL SENSOR SUB-ASSEMBLY FRONT LH 
   1. Disconnect the connector.
      Fig 1: Disconnecting Connector

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Remove the bolt and disconnect the height control sensor link from the lower arm.
      Fig 2: Identifying Bolt And Height Control Sensor Link

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Remove the 2 bolts and detach the 2 clips.
      Fig 3: Identifying Height Control Sensor And Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   4. Remove the height control sensor.
      NOTE: Do not drop the height control sensor. If it is dropped, replace it with a new one.