LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> ES 350 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - System & Component Testing, Removal, Inspection & Installation >> Engine Coolant Temperature Sensor >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Engine Coolant Temperature Sensor: Removal

  1. REMOVE ENGINE UNDER COVER LH 
  2. REMOVE ENGINE UNDER COVER RH 
  3. DRAIN ENGINE COOLANT  (See Drain or Add coolant under ON-VEHICLE INSPECTION )
  4. REMOVE V-BANK COVER SUB-ASSEMBLY  (See REMOVAL )
  5. REMOVE COOL AIR INTAKE DUCT SEAL  (See REMOVAL )
  6. REMOVE ENGINE ROOM SIDE COVER LH  (See REMOVAL )
  7. REMOVE AIR CLEANER INLET ASSEMBLY  (See REMOVAL )
  8. REMOVE AIR CLEANER CAP SUB-ASSEMBLY (See  REMOVAL   ) 
  9. REMOVE AIR CLEANER CASE SUB-ASSEMBLY  (See REMOVAL )
  10. REMOVE NO. 1 AIR CLEANER INLET  (See REMOVAL )
  11. REMOVE ENGINE COOLANT TEMPERATURE SENSOR 
    1. Remove the engine coolant temperature sensor connector.
    2. Remove the engine coolant temperature sensor.
    3. Remove the gasket from the engine coolant temperature sensor.
      Fig 1: Locating Engine Coolant Temperature Sensor Connector
      G04973881Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals