Luggage Compartment Door Open Switch Circuit: Procedure

1. Disconnect the E13 ECU connector.
   Fig 1: Identifying Certification ECU Connector E13 Terminal TSW5

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection (Symbols)	Condition	Specified Condition
   E13-7 (TSW5) - Body ground	Luggage compartment open switch not pushed (OFF)	10 kΩ or higher
   	Luggage compartment open switch pushed (ON)	Below 1 Ω

OK → PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

NG: Go to next step 

1. Disconnect the switch connector.
   Fig 2: Inspecting Luggage Compartment Open Switch

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   R10-1 - R10-2	Luggage compartment open switch not pushed (OFF)	10 kΩ or higher
   	Luggage compartment open switch pushed (ON)	Below 1 Ω

NG → REPLACE LUGGAGE COMPARTMENT OPEN SWITCH 

OK → REPLACE CERTIFICATION ECU