Fuel Tank Pressure Sensor: Installation

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FUEL TANK BREATHER TUBE GASKET
1. Install a new gasket, fuel tank EVAP tube support plate and fuel tank protector plate with the 4 screws
  
  Fig 1: Locating Fuel Tank Breather Tube Gasket Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FUEL PRESSURE SENSOR
1. Install the sensor to the fuel tank vent tube set plate.
  NOTE: Check that there are no scratches or foreign objects on the connecting parts.
  
  Fig 2: Installing Sensor To Fuel Tank Vent Tube Set Plate
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Fix the sensor in place with the tube joint clip
  
  Fig 3: Fixing Sensor In Place With Tube Joint Clip
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  NOTE:
  - Check that the tube joint clip is inserted securely.
  - After installing the tube joint clip, check that the sensor can not be pulled off.
  - Be careful not to damage the tube joint clip. If the tube joint clip is damaged, replace it.
3. Connect the sensor connector.
  
  Fig 4: Connecting Sensor Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 3 FUEL TANK PROTECTOR
1. Install the protector.
  1. Set the protector onto the vent tube set plate.
  2. Turn the protector and install it securely. Then secure the lock.
INSTALL FUEL TANK ASSEMBLY
1. Install the fuel tank (See INSTALLATION ).