Driving Support Ecu: Installation

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.

HINT

A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS ).

INSTALL DRIVING SUPPORT ECU
1. Install the ECU with the nut.
  NOTE:
  - Do not use an ECU which has been dropped or subjected to any strong shocks.
  - During the removal and installation, do not remove the drip-proof cover.
  - When a new ECU is installed, perform initialization.
  Fig 1: Locating Driving Support ECU Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL DASH PANEL EXTENSION LH
1. Install the dash panel extension with the 2 nuts and bolt.
2. Connect the connector.
3. Attach the clamp
Fig 2: Locating Dash Panel Extension Nuts And Bolts With Clamp
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL COWL SIDE TRIM BOARD LH (See INSTALLATION ).
INSTALL FRONT DOOR SCUFF PLATE LH (See INSTALLATION ).