Driver Side Door Entry Unlock Function does not Operate: Procedure

1. When the master switch assembly door control switch is operated, check that the locked doors unlock.

   OK

   Door locks operate normally.

NG → See step   10 

OK: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Main Body / Data List.
5. Read the Data List according to the display on the Techstream.
   MAIN BODY
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   D-Door Lock Pos SW	Driver side door lock position switch signal / ON or OFF	ON: Driver side door unlocked OFF: Driver side door locked	-

   OK

   On the Techstream screen, the display changes between ON and OFF as shown in the chart above.

NG → GO TO POWER DOOR LOCK CONTROL SYSTEM (Proceed to Only Driver Door LOCK/UNLOCK Functions do not Operate) 

OK: Go to next step 

1. Using the Techstream, read the Data List.
   SMART ACCESS
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   D-Door Touch Sensor	Driver side door touch sensor / ON or OFF	ON: Touch sensor touched OFF: Touch sensor not touched	-

   OK

   "ON" (sensor is touched) and "OFF" (sensor is not touched) appears on the screen.

NG → See step   4 

OK → See step   11 

1. Disconnect the E29 ECU connector.
   Fig 1: Identifying E29 ECU Connector And z24 Oscillator Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the z24 oscillator connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   E29-5 (SEL1) - z24-4 (SEL)	Always	Below 1 Ω
   E29-22 (SEN1) - z24-6 (SENS)	Always	Below 1 Ω
   E29-5 (SEL1) - Body ground	Always	10 kΩ or higher
   E29-22 (SEN1) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Disconnect the z23 handle connector.
   Fig 2: Identifying z23 Handle Connector And z24 Oscillator Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the z24 oscillator connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   z23-6 (SGT) - z24-2 (SGT)	Always	Below 1 Ω
   z23-6 (SGT) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Replace the door electrical key oscillator . Refer to DISASSEMBLY - Step 40 .

NEXT: Go to next step 

1. Check that the entry function operates normally.

   OK

   Operates normally.

NG → See step   8 

OK → END (DOOR ELECTRICAL KEY OSCILLATOR IS DEFECTIVE) 

1. Replace the front door outside handle . Refer to DISASSEMBLY - Step 31 .

NEXT: Go to next step 

1. Check that the entry function operates normally.

   OK

   Operates normally.

NG → See step   11 

OK → END (FRONT DOOR OUTSIDE HANDLE IS DEFECTIVE)