Stereo Component Amplifier Power Source Circuit: Procedure

INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY

Disconnect the stereo component amplifier assembly connector.

Fig 1: M29 Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Measure the resistance according to the value(s) in the table below.

Standard Resistance

Tester Connection	Condition	Specified Condition
M29-2 (GND) - Body ground	Always	Below 1 Ω
M29-6 (GND2) - Body ground	Always	Below 1 Ω

Measure the voltage according to the value(s) in the table below.

Standard Voltage

Tester Connection	Condition	Specified Condition
M29-1 (+B) - M29-2 (GND)*1	Always	11 to 14 V
M29-3 (+B2) - M29-2 (GND)	Always	11 to 14 V

TEXT IN ILLUSTRATION

*A	w/ Rear Header Speaker
*1	Front view of wire harness connector (to Stereo Component Amplifier Assembly)

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR

OK → See step 2

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE