Wireless Transmitter Memory Function does not Operate: Procedure

1. Using the standard operation procedure, check that the wireless door lock / unlock operates normally.

   OK

   Wireless door lock / unlock operates normally.

   HINT: 

   The standard operating procedure is as follows:

   Hold the transmitter approximately 1 m (3.28 ft.) from the driver door outside handle. Press and hold the transmitter's LOCK or UNLOCK switch for 1 second.

NG → GO TO  WIRELESS DOOR LOCK CONTROL SYSTEM  WIRELESS DOOR LOCK CONTROL SYSTEM 

OK: Go to next step 

1. Perform a memory operation properly. Check that the buzzer sounds to indicate the completion of the memory operation.
   NOTE:

   • The seat position will not be recorded if the SET switch and 2 or more of the memory switches (for example, M1 and M2) are pressed simultaneously.
   • If a memorizing operation has failed, release all switches. The seat memory function does not operate unless the switches are released.

   OK

   Seat memory switch function operates normally.

NG → GO TO  PROBLEM SYMPTOMS TABLE  PROBLEM SYMPTOMS TABLE 

OK: Go to next step 

1. While pressing the M1, M2 or M3 switch, press the transmitter's LOCK or UNLOCK switch. Check that the buzzer sounds normally.

   OK

   Buzzer sounds normally.

NG → REPLACE POSITION CONTROL ECU AND SWITCH ASSEMBLY LH 

OK → END