Integration Control and Panel Assembly Power Source Circuit: Procedure

1. Disconnect the integration control and panel assembly connector.
   Fig 1: Identifying J54 Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   TEXT IN ILLUSTRATION
   
   

   *1	Front view of wire harness connector (to Integration Control and Panel Assembly)

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   J54-8 (E) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   J54-14 (B) - J54-8 (E)	Always	11 to 14 V
   J54-5 (ACC) - J54-8 (E)	Engine switch on (ACC)	11 to 14 V
   J54-4 (IG+) - J54-8 (E)	Engine switch on (IG)	11 to 14 V

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   2